BoatControl App

BoatControl is not only an App to see the battery capacity of your EPT batteries but also a remote control for your charger. Furthermore it gives you shore power control, 10 extra contacts of your choice and NMEA 2000 interface from your boat data.

VIEWING 
NMEA2000
ELECTRICAL 
PANEL CONTROL
BOAT VIEW
EPT CONTROL

VIEWING NMEA2000


MAKE YOUR DATA AVAILABLE

Whether relaxing on the sofa or sitting in the galley, your data is never further away than your mobile/tablet.

WEATHER INFORMATION

Read your NMEA2000 wind gauge and depth so you know if the weather is right for sailing or if you need to check your moorings.

TANK METERS

See if you need to stop by for water or fuel before heading out.

REMOTE CONTROL ELECTRIC PANEL

SOFA CONTROL

Access your box both at sea and from home. We have taken care of the difficult matters regarding the connections to make it easy for you. Open your App and you’ll be automatically connected to your box with a secure connection.

SIMPLICITY

In BoatControl you can set up the buttons to suit your boat. Naming switches and icons leave you in no doubt about what’s on and what’s off.

EXTRA FEATURES

Your switches can be set up as push-button switches, which can be used for example to control the bow thruster and anchor winch, via a control relay.

EASY INSTALLATION

Our guide makes it easy and straightforward to install BoatControl behind your existing electrical panel, so you keep the original look.

BOAT VIEW

PICTURE OF YOUR BOAT

Take a picture of your boat and use it in the app.

CREATE OVERVIEW

Place the button for the lanterns on the mast and the radio in the cabin. This makes it easy to see what’s on/off.

TURN SWITCHES ON AND OFF DIRECTLY

Pressing the icon in the picture turns the switch on and off.

EPT CONTROL

EPT PROPULSION AND BATTERIES

This page gives you full control over your EPT propulsion and your EPT batteries.

You can monitor your lithium batteries, both for your propulsion and consumption low voltage batteries, shore power and control your charging.

THE BOX

INSTALLATION

We recommend that the box be installed together with the boat’s current electric panel. Once this is done, you can control your contacts directly via phone/tablet with our app. If you choose to connect the box to the internet via wifi, you can always just open the app and manage your contacts equally valid where you are.

THE BOX TECHNICAL SPECIFICATIONS
L x B x H:220 x 116 x 46 mm.
Connection:6.3mm cable lugs, NMEA2000, Wifi and Bluetooth.
Power supply:9 to 30volt DC.
Normal electricity consumption:3w Max 6.5w
Channels/Contacts:110pcs 10A, simultaneous load max 100A
Tell-tales/diodes:1 green per channel, 1 red for supply voltage.
Manual contact:1 Push Switch.
Mounting:Vertical or horizontal.

Additional Information